多项选择题
Which interface commands would you enter on a Catalyst 2900 switch, if your goal was to bring all VLAN traffic to another directly connected switch?（）
A. Switch(config-if)# vlan all
B. Switch(config-if)# switchport trunk encapsulation dot1q
C. Switch(config-if)# switchport access vlan all
D. Switch(config-if)# switchport mode trunk
E. Switch(config-if)# switchport access vlan 303
相关考题
-
多项选择题
You are the network administrator at TestKing. You need to perform password recovery on Router TK1. What must you modify in the password recovery process?（）
A. Configuration register
B. NVRAM
C. Boot flash
D. CMOS
E. Flash -
单项选择题
After making some network changes you power off and then power on your Cisco router. What sequence of events occurs when a router is powered up?（）
A. Perform POST, locate configuration statements, apply configuration statements, locate Cisco IOS software, and load Cisco IOS software.
B. Locate Cisco IOS software, load Cisco IOS software, locate configuration statements, apply configuration statements, and perform POST.
C. Test software routines, POST, load configuration files, load Cisco IOS software, test Cisco IOS software.
D.POST, locate Cisco IOS software, load the Cisco IOS software, locate configuration statements, and apply configuration statements.
E. Load and test IOS, load configuration files, test software routines, POST. -
单项选择题
You are unable to connect to the TESTKING1 router. Which of the following command sequences will correct this problem?（）
A.
B.
C.
D.
E.
F.
