单项选择题
Which one of the following EIGRP commands can check the IP addresses of the adjacent neighbors, as well as verifying the EIGRP retransmit intervals and queue counts?（）
A. TK1#show ip eigrp adjacency
B. TK1#show ip eigrp topology
C. TK1#show ip eigrp interfaces
D. TK1#show ip eigrp neighbors
E. None of the above
相关考题
-
单项选择题
A new router, named TK1, is being installed. You wish to add this router to your existing OSPF network. In doing so, you configure the following: TK1(config)# router ospf 1 TK1(config-router)# network 10.10.10.0 255.255.255.0 area 0 After making this change, you notice that the networks attached to TK1 are not being learned by the other OSPF routers. What could be the cause of this?（）
A. The AS is not correctly configured
B. The network subnet mask is incorrectly configured
C. The network wildcard mask is configured incorrectly
D. The network number is not correctly configured
E. The process id is configured incorrectly
F. None of the above -
单项选择题
On your OSPF network, routers TK1 and TK2 belong to the same Ethernet network. However, they are unable to establish an adjacency over this link. While troubleshooting this problem, you issue the "show ip ospf interface Ethernet 0"command on each router. The output from these commands is displayed below: What is the underlying cause of the routers failing to become adjacent?（）
A. The OSPF area is misconfigured.
B. The priority on TK2 should be set lower.
C. The cost on TK2 should be set lower.
D. The hello and dead timers are misconfigured.
E. You need to add a backup designated router to the network.
F. The OSPF process ID numbers do not match.
-
多项选择题
While trying to diagnose a routing problem in the network, you issue RIP debugging as displayed below: RtrA#debug ip rip Rip protocol debugging is on RtrA# 1d05h: RIP: sending v1 update to 255.255.255.255 via FastEthernet0/0 (172.16.1.1) 1d05h: RIP: build update entries 1d05h: network 10.0.0.0 metric 1 1d05h: network 192.168.1.0 metric 2 1d05h: RIP: sending v1 update to 255.255.255.255 via Serial0/0 (10.0.8.1) 1d05h: RIP: build update entries 1d05h: network 172.16.0.0 metric 1 RtrA# 1d05h: RIP: received v1 update from 10.0.15.2 on Serial0/0 1d05h: 192.168.1.0 in 1 hops 1d05h: 192.168.0 in 16 hops (inaccessible) Based on the output of the above exhibit, which two of the following statements are true?（）
A. A ping to 10.0.15.2 will be successful.
B. RtrA has three interfaces that will take part in the RIP process.
C. There are at least two routers participating in the RIP process.
D. A ping to 192.168.168.2 will be successful.
