单项选择题
What is the purpose of assigning an IP address to a switch?（）
A. Provides local hosts with a default gateway address
B. Allows remote management of the switch.
C. Allows the switch to respond to ARP requests between two hosts
D. Ensures that hosts on the same LAN can communicate with each other.
相关考题
-
单项选择题
As a TestKing trainee you are required to set the default gateway on a Cisco switch to the IP address of 192.168.1.115. Which IOS command should you use?（）
A. TestKSwitch(config)# ip route-default 192.168.1.115
B. TestKSwitch(config)# ip default-gateway 192.168.1.115
C. TestKSwitch(config)# ip route 192.168.1.115 0.0.0.0
D. TestKSwitch(config)# ip default-network 192.168.1.115 -
多项选择题
Which interface commands would you enter on a Catalyst 2900 switch, if your goal was to bring all VLAN traffic to another directly connected switch?（）
A. Switch(config-if)# vlan all
B. Switch(config-if)# switchport trunk encapsulation dot1q
C. Switch(config-if)# switchport access vlan all
D. Switch(config-if)# switchport mode trunk
E. Switch(config-if)# switchport access vlan 303 -
多项选择题
You are the network administrator at TestKing. You need to perform password recovery on Router TK1. What must you modify in the password recovery process?（）
A. Configuration register
B. NVRAM
C. Boot flash
D. CMOS
E. Flash
